Home
DIY tutorials

Amazingly simple: Ring in less than 3 minutes! +VIDEO TUTORIAL

DIY tutorials

Jewelry is never enough…If you want to please yourself or need a small thing as a gift, feel free to start making our yin ring. It's a real toy and a SUPER result! See the top of the video procedure!

Need:

Soft wire (colored copper wires can be found on the Internet or in a shop with beads, a few meters will cost you a few crowns.)
Scissors or pliers

How to do it: 

The length of the wire will affect the size of the resulting flowers, it depends on whether you make jewelry for a little lady or an adult lady.Just make one test ring and you can adjust the length of the wire as needed. The size of the ring can be easily adjusted.The minimum length of the wire depends on its strength, but it is approximately 20 cm.

1. Bend the wire around the index finger so that both ends of it are equally long.

2. We cross the two ends, in the connected place we grasp the wires and rotate them around each other.

3
3. We twist until we have both ends twisted along the entire length into one.

4. Just at the finger we begin to shape the base of the ylet from the wire – we simply turn the wire around.

5. We proceed from the center outwards, so gradually increasing the diameter of the wheel/flower.
6. We remove the ring from the finger, adjust the size by twisting the ring ring in the opposite direction, before twisting the ends of the wires at point 2.We put the free end of the braided wire at the bottom of the plant and we're done.

 

 

 

 

 

Our tip: Before step No.2 you can string a larger bead on the wires
and step No. 4 then you will twist the wire around it.
Thus, you will get a variation – a flower with a colored center.

 

 

Procedure and photo: Gabuschka

 

 

 

 

 

 

jak si udelat

e-mail: redakce@jaksiudelat.cz

Zásady ochrany soukromí GDPR